If you use a gas-powered weed eater, things can get messy sometimes.
That’s because these models run on fuel and heavily depend on fuel filters for running smoothly. To keep your device in top-notch condition for a long time, you’ll have to routinely clean it.
Not sure how to do that? Do read my guide on “how to clean fuel filter on weed eater” to get all the details.
How To Clean Fuel Filter On Weed Eater
1. Gather The Tools
The first step to fixing anything is getting the tools right. So, for cleaning the fuel filter of your weed eater, you’ll need a gas can, funnel, a pair of needle-nose pliers, some mild soap, water, compressed gas, and a clean towel. And if you want to be on the safe side, you can put on safety goggles and gloves as well.
2. Pull Out The Spark Plug
Remove the spark plug beforehand to make sure the weed eater doesn’t accidentally start while you’re cleaning. You can do that by loosening it using an adjustable wrench.
3. Empty The Gas
For thorough cleaning, you’ll have to get rid of the fuel present in the weed eater. Place the empty gas can on a flat surface and place a funnel in its spout. Now, cautiously tilt the device after removing its gas cap and drain all the fuel into the can.
4. Find The Fuel Filter
Moving on, find the gas line connected to the fuel tank and pick it out using needle-nose pliers. The fuel filter is attached to the end of this tube, so you’ll have to remove it entirely from the weed eater.
Moreover, some models have two fuel lines for suction and return, but the filter is present only on one of them. Therefore, you should check which one has it and remove the filter accordingly.
5. Clean The Filter
After getting a hold of the filter, clean it properly using dish soap, brush, and water. The best way to go about this is by soaking it for a while and rinsing after a good scrub. Do this till the water runs clear for the best results.
Once you’re done cleaning the filter, dry it with the help of compressed gas or a clean towel. And don’t put it back until it’s completely dry.
6. Replace All Parts
Connect the fuel filter with the gas line and insert it in the gas tank. Lastly, fill it up with fuel and replace the spark plug. Now, pull the starting cord and see if the weed eater works fine. Things should go smoothly; otherwise, you can call up a professional.
Final Words
Although a gas-powered weed eater looks high-maintenance, you can maintain it in its prime with a little bit of cleaning. Now that you know how to do that, hopefully, you’ll be able to trim all the weeds without any hiccups.
Until next time!