A weed eater is one of the most important tools that a gardener can have in his toolshed.
From trimming grass to keeping your garden free from weeds, weed eaters come in handy for a variety of tasks. Despite being a gardener’s best friend, a weed eater may become challenging to use because of its tangled pull cord.
So, if you want to untangle the pull cord of your weed eater within minutes, I’ve got you covered with this informative guide.
How To Fix Weed Eater Pull Cord?
While the pull cord of a lawnmower is easy to fix, this isn’t the case for a weed eater. That’s because you’ll have to completely dismantle the motor housing to access the pull cord recoil housing.
After that, you’ll have to change the spring because that’s where the problem usually lies. In some instances, the cords require replacement, so you may need to do that.
How To Access The Recoil Mechanism?
While most models require extra disassembly, some can be fixed by removing the plastic cover and screws. The hard work required depends upon your model.
To get to the recoil mechanism, here’s what you’ll have to do:
1. Detach The Trimmer Shaft
First off, you’ll have to remove the trimmer shaft from the engine housing by unfastening the screws that hold it. After that, pull off the carburetor bracket with needle-nose pliers to disconnect the throttle cable and detach the shaft.
2. Bind The Piston
Next, disconnect the spark plug and insert a piece of rope or rag into its hole. This must be done very carefully to prevent the engine from rotating while removing the clutch drum.
3. Remove The Clutch Drum And Clutch Plates
To remove the clutch drum, you’ll have to use a screwdriver and rotate it counterclockwise. After that, use a flat-headed screwdriver and a hammer to rotate the clutch plate counterclockwise. Remove the clutch plates and repeat the procedure to unscrew the others.
4. Dismantle The Motor Housing
After removing the clutch drum and plates, disassemble the motor housing by loosening the screws. Finally, remove the plate to access the recoil mechanism. Also, keep in mind that dismantling varies from model to model.
Now you’ll have to service the recoil mechanism and follow the same procedure in reverse to reassemble the weed eater.
Summing It Up
So, that was about how to fix weed eater pull cord. Having a weed eater is an absolute necessity to maintain lush, thick beautiful lawns. Just make sure the pull cords don’t tangle, and even if they do, this guide will come in handy to untangle it.Â
With that said, it’s finally time to wrap up my guide. Hopefully, you enjoyed reading my guide as much as I enjoyed writing it. Until next time. Stay safe and take care!Â