If your basement is looking too dark and spooky to use, consider installing electrical outlets in it.
Although the project is relatively simple, there are a couple of important things you need to keep in mind. You need to gauge whether the basement will be dry, wet, or damp before choosing the right kind of cables to install in it.
Take a look at my guide to know how to add outlets in basement.
How To Add Outlets In Basement
Before I began my project, I took into account the type of appliances I would be using in the basement. Then, I decided how many receptacles I needed to add to the circuit, and finally got all the right tools required for the job.
I also recommend finding out whether you need to get GFCI protected receptacles or not before you begin purchasing the necessary items. Here are the simple steps of adding outlets in your basement.
Step 1
The first thing you need to do is to mark the point on the wall where you will install the Handy Box. I positioned mine 48 inches from the ground, but there is no such set rule for how high or low you can position yours. Mark the place carefully using a pen using diagonal spots for the box.
Step 2
Next, begin drilling the mounting holes using the correct masonry bit size. Use a hammer to place the plastic anchors in their place. You will find knockouts at the end of the Handy Box - remove one of them to install the ⅜-inch cable connector and carefully secure the Handy Box to the wall.
Step 3
Now, route the cable to the box through the ½-inch holes using a spade bit. When you insert the cable, ensure that there is at least 6 to 8 inches of space to project it from the box. Tighten the screws and secure the cable using the plastic wall anchors and cable straps.
You should secure this cable 6 inches from the Handy Box using intervals of a maximum of 48 inches.
Step 4
Remove the outer jacket from the cable and 1-inch from the ends of each conductor. Begin looping the black, bare, and white ends of the conductors and attach the black wire end underneath the screw on the receptacle. Do the same with the white and bare wires.
Step 5
Once it is done, secure the terminals using tape and add the cover for the box. Turn off the main circuit breaker from the service panel and install the remaining cable connector to the panel box.
Then, insert the necessary cable into the panel and connect the white and black wires to the screws. However, the bare conductor should be connected to the ground bar of the panel. Place the covers and switch on the main breaker.
Conclusion
These were the easy steps to add outlets in your basement.
I hope my guide helped you do this easily at home. However, don’t hesitate to take professional help if required. And always do any electrical work with caution and the right protective gear.
Stay safe!